Motorbike two way radio hands-free kit PowerCom ROGER 10

The fit-for-motorbike hands-free kit for two-way radio of the new AKE-PowerCom series

Everything under control? - Everything is Roger!

Fit-for-motorbike hands-free kit with intelligent driving noise compensation and automatic volume adjustment, space-saving placed in a solid aluminium case.

The ROGER 10 has a fit-for-motorbike voice control (VOX) and enables a hands-free voice communication via two-way radio of your choice from motor-bike to motorbike.

The ROGER 10 is fit for very high driving speeds when using an adequate helmet set.

An optional Bluetooth module enabled at request the wireless connection to the mobile phone.

Important device features:

• No manual handling necessary while driving:
  Automatic volume control of the two-way radio reception signal depending on the driving noise.
  
  
• Fit for motorbike two-way radio hands-free kit:
  
  • Driving noise compensated automatic voice control (fit-for-motorbike VOX) activates the two-way radio.
  • The ROGER 10 recognizes automatically the activity of the connected two-way radio.
  • Not one word will get lost as any delay in the response of the two-way radio is electronically compensated when using AKE recommended two-way radios.
  • Manual handling is possible by using the optional operating device or with a separate transmission button.
    
    
• Always the right voice volume:
  ROGER 10 has a driving noise dependent modulation adjustment: Whatever speed you will drive, everybody will hear your voice clearly and understandably.
  (Die Übertragungsqualität eines Funkgerätes hängt von der richtig eingestellten Modulation ab. Da aber die Sprechlautstärke auf dem Motorrad fahrgeräuschabhängig stark variiert, wird nur mit einer automatischen Modulationsanpassung immer die bestmögliche Signalqualität erreicht.)
  
  
• Effective elimination of disturbing driving noise:
  
  • Extensive filters reduce the driving noise.
  • If nobody is talking, a fit for motorbike voice-switch ensures also at high speed a soft muting of the microphone signals.
  • The helmet microphone is switched off completely if it is not needed, e.g. with deactivated VOX and when not pressing the transmission button.
  
  
• Various adjustment settings:
  Lowest voice volume level, driving noise compensation, volume of internal sound level and two-way radio modulation may be adjusted individually.
  
  
• Easiest handling because of power supply by the mo-torbike:
  No changing or recharging of batteries necessary.
  
  
• Less mounting effort because of automatic power-on of the power supply:
  Plugging in the helmet connector will automatically power-on the ROGER 10. This allows to connect the system directly to the battery of the vehicle or optional to any 12V power plug.
  
  
• Practical power-on of accessories:
  This function allows automatically to power-on connected devices like two-way radio, if desired. Simply plug in helmet connector and start driving.
  
  
• Extensive integrated vehicle dejam facilities:
  Save time and money. ROGER 10 is extremely save from electronic vehicle jam. Also the operation on CAN-Bus power supply is allowed.
  
  
• Robust assembly for harsh operation:
  ROGER 10 is installed in a solid water protected alu-minium case. It has weatherproof helmet plug outlets equipped with raised markers for easy plugging in at the correct position, even with gloves. The electronics are protected by an automatic power-off against over and under voltage. All amplifier outputs are short-circuit-proof and are equipped with overload protection.
  
  
• Two-way radio connection are laid out universally:
  Decide for yourself which two-way radio you will connect. The ROGER 10 will register what kind of microphone is being used and adjust automatically. Optionally available connecting cables allow connecting various types of two-way radios (CB-, LPD-, PMR- and oth-ers) via loudspeaker or headphone output.
  
  
• Adequate helmet sets:
  High quality helmet installation sets are available for full face helmets, flip-up helmets and open face hel-mets. On demand, we take care of the installation into your helmet.
  
  
• Dimensions: 70 x 149 x 20mm
  

Device connectors:

• Helmet of driver
• two-way radio
• operating device
• power 12V
• power-on automatic for accessories

Scope of delivery: